(WAIT WITH UPLOAD) How do I enable Continuous or Non-Continuous Rapid Trigger?Updated 14 days ago

Continuous and Non-Continuous Rapid Trigger differ in one thing: where in the key travel Rapid Trigger is allowed to operate. Non-Continuous keeps your Actuation Point meaningful, while Continuous makes the entire key travel active.

Non-Continuous Rapid Trigger:

Rapid Trigger only operates below your Actuation Point. Once the key rises back above the Actuation Point, it fully resets. The Actuation Point still acts as a hard boundary between active and inactive.

More forgiving: Resting a key above the Actuation Point never triggers it.

Predictable: Your Actuation Point keeps its meaning. Rapid Trigger only speeds up resets below it.

Continuous Rapid Trigger:

Rapid Trigger operates across the entire key travel. After the first press, the key only fully resets when it is completely released. Any downward movement will activate it again, anywhere in the travel.

Maximum responsiveness: Micro adjustments register even when the key is barely pressed.

Less forgiving: A heavy resting finger can trigger a key you meant to release. Please pair it with sensible sensitivity values.

How to enable each mode:

Mode selection is done in the WALLHACK Terminal Rapid Trigger tab. On the K-001 it is a single toggle: CONTINUOUS RAPID TRIGGER on or off (off = Non-Continuous, the standard behaviour).

Open WALLHACK Terminal at terminal.wallhack.com and click CONNECT DEVICE. Select WALLHACK K-001 in the browser’s device prompt and confirm.

Select your profile, then open the RAPID TRIGGER tab.

Set ENABLE RAPID TRIGGER to ON and set GLOBAL RT SENSITIVITY (0.10 mm to 3.20 mm, in 0.05 mm steps). The default RT value is 0.4 mm.

Note: The maximum value depends on the switch currently installed and calibrated in WALLHACK Terminal. The default maximum is 3.20 mm.

Turn on SEPARATE PRESS AND RELEASE and set PRESS SENSITIVITY and RELEASE SENSITIVITY individually for different press and release behaviour. 

Set CONTINUOUS RAPID TRIGGER to ON for Continuous mode, or leave it OFF for standard Non-Continuous behaviour.

On-board Rapid Trigger Mode (FN + RT) adjusts the Rapid Trigger sensitivity for all keys. The choice between Continuous and Non-Continuous only lives in WALLHACK Terminal."